FULL 3D Design Plans for 9-cell from professional

Optimus

FULL 3D Design Plans for 9-cell from professional
« on February 26th, 2021, 05:53 AM »Last edited on February 26th, 2021, 06:03 AM
Hello fellow tinkerers,

Daniel has asked me to do a professional 3D design of the 9-tube cell and since I want to contribute to the re-invention of stanley meyer technology I did so.

Plans for you for free now... Now I need help to drive the cell. So I do the plans for you and would be very happy to receive some help for the circuits in exchange. So feel free to contact me at any time! Definitly need your help for the circuits...

The design is based on this thread: https://open-source-energy.org/?topic=2704.0

Enjoy... :cool:

Earl

Re: FULL 3D Design Plans for 9-cell from professional
« Reply #3, on February 26th, 2021, 08:44 AM »
I have build most of Stan's basic circuits from scratch and posted an analysis of their function and my test results in the forum.  I have also built and tested the PCB versions of these same circuits that Daniel has developed.  Based on that process Daniel plans to release updated versions.  Having done it both ways it is much easier to build the PCB versions and he even has the VIC Matrix board which is a backplane card to hold cards.  Daniel and I are also working on a document that is collection my documents and his in one place so it is available to help others.  Initial versions of that document have been posted in this forum.

As you are already in contact with Daniel he can provide more information.

Earl



securesupplies

Re: FULL 3D Design Plans for 9-cell from professional
« Reply #5, on February 26th, 2021, 09:25 AM »Last edited on February 26th, 2021, 12:11 PM
Hi Optimus
The Beach Top Mains Power Chopper Stan Made to drive this Cell
 8xa/9xb(with 9xb built in)  and scr switch.

A Important note is we  know all cells connected in pairs ,
 stan may have discovered that after this cell was made.

so use 1 tube as steam resonator.  of coarse it work fine if all 9 just 
slightly more gain is in pairs as the inner and outer balance when in series

latter you can replace 8xa/9xb with a gated  version called 9xa

Dan

securesupplies

Re: FULL 3D Design Plans for 9-cell from professional
« Reply #6, on March 11th, 2021, 10:26 AM »
Missing and now found

OPtimus I was reviewing the Files and noticed this was no in the Stp or 3 d object etc IGES

I put this together with some   notes which are closer to stand original
1 Vents in side for gas  rising
2 mounts small holes it appears stand made some little bracket to hold the spacer securely


DD