Hey Apoch,
Your prints are finished and all you see in the picture you'll receive in the Box. I ran out of filament on the back ones and then had an awful clog on the first small gears I tried printing because the retraction settings where a little off. With a little bit of epoxy resin that back large gear can still be used though I increase the infill on the newer one for more strength and there's a slight bit warping on the old one.
I hope you're able to use these for what you had in mind and it'd be awesome to see a video of your final build. Let me know what you think and if you still want them.
Much love,
Diadon
Oops, my silly phone put it into a new thread... ! Sorry about that, this was suppose to be a reply message to Apoch4lypse.
Your prints are finished and all you see in the picture you'll receive in the Box. I ran out of filament on the back ones and then had an awful clog on the first small gears I tried printing because the retraction settings where a little off. With a little bit of epoxy resin that back large gear can still be used though I increase the infill on the newer one for more strength and there's a slight bit warping on the old one.
I hope you're able to use these for what you had in mind and it'd be awesome to see a video of your final build. Let me know what you think and if you still want them.
Much love,
Diadon
Posted: June 27th, 2017, 01:31 AM
Oops, my silly phone put it into a new thread... ! Sorry about that, this was suppose to be a reply message to Apoch4lypse.