Hey all,
being back after 4 years break. My personal mind is, water is the key to clean and unlimited energie. From my last experiments with magnetfileds i had a lot magnets left and combine them with the Stan Meyer Tube.
I started condition the tube within a strong magnetic and 12V/0.5A DC, no puls. Just used a regular ampre controld 12V/3A power supply.
The condition cycle was 1h on -> remove water -> 30min dry -> refill with tap water and start again. Some times i used salted water to proof the current consumtion. After guess tow days the power supply was gone, overheated, the transformer fused. I cleanded the reactor and would like to check the surface of the cathode tube. Than i saw this may tiny hole's and couldn't explain it. I know whats happend, but in my reactor ? with 12V - 0.5A ??? I searched for 2 days in the internet and could not find any similar picture or explanation. corrosion looks different. Does anyone has a hint ?
being back after 4 years break. My personal mind is, water is the key to clean and unlimited energie. From my last experiments with magnetfileds i had a lot magnets left and combine them with the Stan Meyer Tube.
I started condition the tube within a strong magnetic and 12V/0.5A DC, no puls. Just used a regular ampre controld 12V/3A power supply.
The condition cycle was 1h on -> remove water -> 30min dry -> refill with tap water and start again. Some times i used salted water to proof the current consumtion. After guess tow days the power supply was gone, overheated, the transformer fused. I cleanded the reactor and would like to check the surface of the cathode tube. Than i saw this may tiny hole's and couldn't explain it. I know whats happend, but in my reactor ? with 12V - 0.5A ??? I searched for 2 days in the internet and could not find any similar picture or explanation. corrosion looks different. Does anyone has a hint ?