advancing the Solid state Tesla hairpin circuit


« Reply #225,  »
just tested the counter wound bifilar coil as L1, and it works. lower voltage needed, and naturally a higher current.

Magnetic field is south on both sides (or north if polarity is reversed).

If Ken Wheeler is right, the south pole is centripetal, a influwing vortex, north is a centrifugal outflowing vortex.
Both sides of the counterwound bifilar coil have a inflowing south vortex pole.
The north poles  are squashed in between the windings, and from what I have seen from the ferro cell, when two magnets are in opposition a new dielectric field is created in between them. so now we have a south pole vortex on each side of the pole and a dielectric field in between the windings.

Also could mean, with south on the inside, a inflowing dielectric field is generated bewtween the windings, and outlfowing north on each side...

the series connection can be chosen on the outside or inside rim of the bifilar coil. The voltage difference between the supplied voltage/current will create also a local dielectric field. but this one will probably neglect-able.

compass needle shows same poles on each side of the coil. at the outside rim, there the needle also deviates, showing a influx or out flux. interesting stuff...

bifilar coil, is series and parallel resonant at the same time
« Reply #227,  »
Attached pictures explains all.
simultaneous parallel resonant AND series resonance

 20190812_200614.jpg - 1001.81 kB, 2560x1440, viewed 23 times.

 20190812_200533.jpg - 980.52 kB, 2560x1440, viewed 32 times.

Re: advancing the Solid state Tesla hairpin circuit
« Reply #228,  »
I worked out several scripts for new videos and have started recording new video material (for my master ivo channel).

stepping back from the research was a good choice.
my mind is becoming clearer again, and I have better perspective on whats going on.

no promises, but I intend to make multiple videos, showing/explaining
the fields of the coil
the series resonant bifilar coil
the impulsed series resonant coil

coloured in bifilar coil from patent 512340
« Reply #229,  »
including voltage relationships

 20190821_225436.jpg - 1572.4 kB, 2560x1440, viewed 19 times.

cap impedance change from impulse
« Reply #230,  »
I'm still working on a series of new videos. making good progress.
While in production, I do not experiment, and this bring my mimd into focus. A lot becomes clear.

One of the things I encountered, and showed in the radiant power video (master Ivo, youtube) is the reduced power draw when L1 and L2 are coupled. And still it produced large Impulses.

These Impulses are a representation of the magnetic field energy, So with the reduced power draw, they are over unity by them selve (I think, but need to test).

These Impulses can charge up caps really fast, as if the caps are much smaller.
Tesla has a patent on this 462418

I really like to see how this all works. I have many ideas, and will test in the future.
but for now, I stick to the videos production.
Tesla exta coil, as impulse amplifier, through higher harmonic
« Reply #231,  »
First video is finished. Got several more im production.

meantime, I have been thinking about how to amplify the impulse voltage.

It seems Tesla's "extra coil"  holds the answer.

instead of magnetic coupling amplification, which loads down the source,
I will use the loose dielectric coupling.

this means using a resonant coupled coil(secondary) .
the resonant frequency of the "extra coil" will be a higher harmonic of the series resonant L2 coil (primairy)

due to the higher frequency, the impulse duration will be shorter, and the impulse voltage higher.

the L3 could be grounded, on the series resonant  L2, between the l2 coil and the series tuning cap (where the resonant voltage meets the impulse).

I wonder if L1 then also acts on a harmony of the l2 and l3. but thats for later.