open-source-energy.org

Open - Source - Research => Open-Source Research => HHO / Browns Gas / Hydroxy / Stan Meyer => Topic started by: Heuristicobfuscation on September 5th, 2013, 05:20 PM

Title: PLL Circuit
Post by: Heuristicobfuscation on September 5th, 2013, 05:20 PM

Whats the simplest way to build a PLL circuit with resonant scanning?

In Stan's patents he shows the electrical diagram of the PLL but it fails to mention
the electronic microchip used. check image bellow...

I know he used this circuit for the resonant cavity in the dune buggy,
but I would like to apply this to his  [figure 8xa voltage intensifier circuit .memo420]   I may have to use an additional winding on the coil for the pickup sensor what do you guys think?

Title: RE: PLL Circuit
Post by: Lynx on September 5th, 2013, 11:46 PM

Quote from Heuristicobfuscation on September 5th, 2013, 05:20 PM

I may have to use an additional winding on the coil for the pickup sensor what do you guys think?

I think you're correct, if I were to build a PLL the feedback to that circuit would be a pickup coil on the VIC/transformer.
Attached some food for thought (http://i1306.photobucket.com/albums/s566/4lynx4/Fun/smile.png)

Title: RE: PLL Circuit
Post by: Heuristicobfuscation on September 6th, 2013, 03:19 PM

Quote from Lynx on September 5th, 2013, 11:46 PM

Quote from Heuristicobfuscation on September 5th, 2013, 05:20 PM

I may have to use an additional winding on the coil for the pickup sensor what do you guys think?

I think you're correct, if I were to build a PLL the feedback to that circuit would be a pickup coil on the VIC/transformer.
Attached some food for thought (http://i1306.photobucket.com/albums/s566/4lynx4/Fun/smile.png)

Thanks for the pdf's this will get me started in right track...i will have to do my homework...