open-source-energy.org
›
OPEN-SOURCE-ENERGY.ORG
›
RWGRESEARCH.COM 
Engine Management System ECU and systems MAPS
Engine Management System ECU and systems MAPS
|
Engine Management System ECU and systems MAPS
|
|
03-07-2012, 03:05 PM
Post: #1
|
|||
|
|||
|
Engine Management System ECU and systems MAPS
This Thread is started to to bring together the overall engine management system knowledge and , options for after market ecu ,injector ignition off the shelf or custom system over lays.
I started with this one from Stan which I hope every here enjoys to see again Patent number: 5293857 attached Note Particular interest is the gas mixing chamber and ambient air in to gas processor with gate (throttle body which is connected to ecu for accelerator position) and figure 3 Several companies can offer pcs, omnitek is great one. Other patents which help the common knowledge of ecm operation with hydrogen injections on vehicles US7316218 Dan |
|||
|
|
03-08-2012, 06:02 AM
Post: #2
|
|||
|
|||
RE: Engine Management System ECU and systems MAPS
(03-07-2012 03:05 PM)securesupplies Wrote: This Thread is started to to bring together the overall engine management system knowledge and , options for after market ecu ,injector ignition off the shelf or custom system over lays. good post, and also i will add my thought here later, had done some research on this also... ~Russ "I had to go to a source of power greater than Stan Meyer in order to try and bring in this form of technology. And the Lord said that this knowledge of pertaining to water when he was talking to Job and he asked Job the question. He said, "Job have you ever considered the treasures of snow or have you ever considered the treasures of Hell which I have reserved against the time or trouble against battle and war". And the reason I am here today is that the multi international corporate structures can't bring in this type of technology, the Federal governments cannot bring in this technology, it has to come through an individual such as myself and it has to move through you and I. So as I impart this technology onto you, then you have a responsibility to it. This technology must get in through the people or otherwise it will not go forward." - Stan Meyer "We can demonstrate the technology. We can say it’s here but in actuality it will not be Stan Meyers to bring it in. It will be either you or I, the guy down the street, who will come together to bring it in. Otherwise, I do not believe an alternate energy source, whether water fuel cell or other, would ever come in. It’s going to have to be mandated by the people to try to reverse the environmental problems, the environmental damage, that’s actually occurring. - Stan Meyer, 1997" "If you believe, even tho you can not see, you will see." ~Russ Gries |
|||
|
|
|
04-19-2012, 09:47 AM
(This post was last modified: 04-19-2012 09:51 AM by securesupplies.)
Post: #3
|
|||
|
|||
RE: Engine Management System ECU and systems MAPS
(03-08-2012 06:02 AM)~Russ/Rwg42985 Wrote:(03-07-2012 03:05 PM)securesupplies Wrote: This Thread is started to to bring together the overall engine management system knowledge and , options for after market ecu ,injector ignition off the shelf or custom system over lays. OK I HAVE A SMALL CACHE OF LPG GUYS STARTING I WILL POINT THEM TO THIS THREAD PLEASE DO SAME for poeple form installer industry SO THEY DON"T MIX INFO for installing experiences and ideas WITH PURE REBUILD INFORMATION IN OTHER THREAD LIKE INJECTOR ETC HERE CAN BE MAP< ECU SOLENOID , bypass reprogramming and AND TECH KNOW HOW FROM LPG ?CNG INSTALLERS ETC Look forward to Opening it up for development from this industry experiences to date alot has happen since 1985 Some kits on the market are amazingly simply to adjust in software and config. not to mention well made and cost effective. DANIEL |
|||
|
|
|
04-21-2012, 07:45 AM
(This post was last modified: 04-21-2012 03:03 PM by securesupplies.)
Post: #4
|
|||
|
|||
|
CONVERTING CURRENT LPG installer kits: Engine Management System ECU and systems MAPS
FYI for comparing and adapting with YOUR current LPG KNowledge etc
|
|||
|
|
|
04-21-2012, 09:13 AM
Post: #5
|
|||
|
|||
|
RE: Engine Management System ECU and systems MAPS
re post as relevant from tony another forum
Ok after thinking and looking at the locations of VEE and thinking about it from a cars electronics point of view, I've come up with what VEE is. VEE is a 12v supply voltage. If you know anything about a cars electronics, its the ignition switch. On a cars ignition switch you have ACC and then the "Start" position. ACC will turn on the circuit and all other electronic accessories. When the ignition is in the "Start" position this will energize the ignition coil and engage the starter. As far as VEE, when the cars ignition is in the "Start" position, this will turn on the VEE locations allowing the circuit to start producing hydrogen. This also acts as a safety feature so that for example is you have your cars ignition switched to ACC to listen to your radio, you want be producing hydrogen. Pretty simple explanation huh? I think Vdd 5v Vcc 12v or 5v ? Vee 12v Yea VDD = 5V, VCC & VEE = 12v Thanks - this helps clarify the voltage sources for the circuits greatly! dan |
|||
|
|
|
05-02-2012, 06:45 AM
(This post was last modified: 05-02-2012 06:59 AM by securesupplies.)
Post: #7
|
|||
|
|||
|
RE: Engine Management System ECU and systems MAPS
If any one has old VMU or power boxes please send or send with circuit diagram
check this http://www.obdkey.com/vehiclediagnostics.asp (05-02-2012 06:45 AM)securesupplies Wrote: If any one has old VMU or power boxes please send or send with circuit diagram RE This http://www.obdkey.com Tremendous amount of information , http://www.youtube.com/watch?v=957TTByL0...embedded#! |
|||
|
|
|
05-02-2012, 08:47 AM
(This post was last modified: 05-02-2012 09:24 AM by securesupplies.)
Post: #8
|
|||
|
|||
RE: Engine Management System ECU and systems MAPS
(05-02-2012 06:45 AM)securesupplies Wrote: If any one has old VMU or power boxes please send or send with circuit diagram RARE VIDEO http://www.youtube.com/watch?v=sIYeEc02S...r_embedded (05-02-2012 06:45 AM)securesupplies Wrote: If any one has old VMU or power boxes please send or send with circuit diagram modern examples http://www.youtube.com/watch?feature=pla...KGP9N1PY#! AEM Igniton control o2 mao and ignition controller http://www.youtube.com/watch?v=SCeMaLC0D...re=related http://www.aemelectronics.com/ |
|||
|
|
|
06-01-2012, 02:06 AM
Post: #9
|
|||
|
|||
|
RE: Engine Management System ECU and systems MAPS
PLease add to this thread also see Alex VUM Rebuild
thread as a way to auto fine tune rather than manual like stan and stephen did Dan |
|||
|
|
|
10-02-2012, 04:12 PM
Post: #10
|
|||
|
|||
|
RE: Engine Management System ECU and systems MAPS
Fuel injectors
adapt LPG GUys http://www.youtube.com/watch?v=sAtDB2FCG...h_response now a O2 sensor, small micro controller ( Arduino) and short program and you can control the air to fuel ratio. |
|||
|
|
|
06-09-2013, 01:21 PM
Post: #11
|
|||
|
|||
|
RE: Engine Management System ECU and systems MAPS
New
Version of ECU and EMS I have put together the fitting and plumbing I have a manufacture for quenching tube it is a special mould process from ptfe, so I am trying to match he solenoids to tube size at this time to trail that part of it Daniel http://www.securesupplies.biz |
|||
|
|
|
« Next Oldest | Next Newest »
|
| Possibly Related Threads... | |||||
| Thread: | Author | Replies: | Views: | Last Post | |
| Let's build A "Popper" Noble Gas Engine AKA Ppap Engine. | ~Russ/Rwg42985 | 1,957 | 192,506 |
06-04-2013 04:09 PM Last Post: FaradayEZ |
|
 |
Stanley Meyers EPG System | admin | 23 | 11,854 |
05-23-2013 12:08 PM Last Post: securesupplies |
| hho as combastion engine fuel | aquabait | 13 | 664 |
04-22-2013 08:46 AM Last Post: Dog-One |
|
User(s) browsing this thread: 1 Guest(s)