Stan's "Quenching Disk" what it is? And Testing

[Hhydrogen4power]

Nice work on the drawings. Once you see them in 3D it gives you a better idea whats going on. There is an injector for fuel oil on the market that uses some of the same principles. I have one and will try to photo it for the group. It just has the fuel flow not the electrode. The nice thing about it is you can buy one and run your gas threw it for testing. My feeling is it could be cuppled to an electrode assembly for testing the concept of on demand. There is somethings to think about when making a water injector. We need pure gass to inject, if it spits water it will sputter or just stop he reaction. The other issue is pressure, I think the pressure should be around 3000 psi to avoid just making steam from the heat of the plugs location. This would take a second control to open the injector. I is hard to rap around the idea of an open ended injector working. I am here for this technology as strong as the next man:However i would not want to see someone just copy this without looking at the reality that your not copying a proven unit. Locate a new direct injection injector and you will understand what i am talking about.

I dont post much but i do like what Russ has put togeather and the work you are all doing. It will pay off in some fashion. We have a stronger start than the "Cold Fusion" group. There big mistake was asking for validation from the scientific community. I think it is smart to do our own validation. Keep up the good work, we will get there.

David A. Puchta
Hhydrogen4power Youtube
1-858-381-7923 Direct