Tubes surfaces

Marco

Tubes surfaces
«  »
Hi everyone,

This is a reflexion i had after watching a video of Max Miller explaining the WFC on Youtube.

 Outer tube            Inner tube
                   Gaz
   ++++|         O        |----
   ++++|         O        |----
   ++++|         O        |----
   ++++|         O        |----
   ++++|         O        |----
   ++++|         O        |----
   ++++|+++++x-------|----
   ++++|                    |----
   ++++|                    |----
   ++++|                    |----
   ++++|                    |----
   ++++|                    |----

    GOOD (minimum amperage)
You have the same potential in the two tubes.



   ++++|                   O|-
   ++++|                   O|-
   ++++|                   O|-
   ++++|                   O|-
   ++++|                   O|-
   ++++|                   O|-
   ++++|++++++++++x|-
   ++++|                      |-
   ++++|                      |-
   ++++|                      |-
   ++++|                      |-
   ++++|                      |-

    BAD (Short circuit, raise of amperage)
The positive is much larger than the negative.

The surface of the outer tube is bigger than the surface the inner tube.
This is why Stan Meyer did the cuts on his (see videos).

Is this make any sense to you ?

Marco
Re: Tubes surfaces
« Reply #1,  »
Not about surfaces, something else.
Due to too small cuts on the outer tubes.
Keep searching.